How to Make a Simple Cattle Panel Garden Trellis (That’s Sturdy and Lasts Forever!)

Today we’ll look at how to make a simple cattle panel trellis for the garden.

Along with zip ties and duct tape, cattle panels have many uses on the homestead. When I was visiting my friend Elizabeth a few weeks ago, I saw her little cattle panel garden trellises made from scrap pieces of cattle panel and thought, “hey – that’s just what I need in my Grocery Row gardens!”

These are my Grocery Row gardens:

It’s a system of annuals and perennials I’ve been planting in 4′ wide beds with 3′ wide pathways in between. The crops change with the seasons. Right now we’re harvesting the final round of brassicas: broccoli, cabbage, collards, kohlrabi and mustards. Some are headed into the kitchen to be fermented, canned or frozen while others, like slug-eaten cabbage heads and the remnants of the mustard cover crop, go off to feed the chickens.

As I harvest, gaps are left behind. We’re getting close to summer, so many of the gaps are being planted with okra, bush beans and sweet potatoes. However, there are some super-productive vining vegetables that would be nice to tuck into these beds, such as angle gourds, snake gourds and yard-long beans.

That means we need trellises. This week I am building five of them and may make more. I don’t want anything that requires me running lots of strings. It needs to be sturdy, but I also don’t want anything permanent. When the summer ends, we will probably take these trellises out and re-plant brassicas for the fall.

So I’m building little cattle panel trellises that should serve us quite well for many years to come. Here’s how you can do the same.

First, go buy your cattle panels. They usually come in 16′ sections. I bought 8′ ones instead because I was tying them to a vehicle and the 16′ ones were expensive and had a tighter mesh. You want the wider gaps for climbing vegetables. When you get your panels, buy T-posts as well. We got 6.5′ ones, which are perfect for this job. Now it’s time to build!

Step One: Measure Your Cattle Panel Trellis

I stretched my arms out to measure roughly 6′. If the cattle panel trellis is too tall it may get unwieldy. I stuck an 8′ one in the garden as a test but it feels too tall for me and I’m not sure how it will do with just a single T-post holding it up.

Step Two: Cut Your Cattle Panel

My favorite method is to use a pair of bolt cutters, though in a pinch an angle grinder is good too.

When I cut, I cut in the middle of a row in order to leave sharp ends hanging off. This will make sense in a minute.

Step 3: Take Your Stuff to the Garden

Look at those scary pointy ends! Someone is begging for tetanus!

Step 4: Hammer in a T-post

I have a tubular T-post hammer with grips on either side. It’s a huge improvement over the 2lb sledge I used to use to hammer in posts. Your T-post will go roughly in the middle of your cattle panel, so put it in the middle of your 4′ bed and make it as vertical as you can. Hammer it at least a foot into the ground. The flange at the bottom of a T-post makes it remarkably sturdy.

Step 5: Put the Cattle Panel Against Your Post and Step On it!

Now here’s where those sharp ends come in. I cut the panel so it will have spikes on the bottom. These stick into the ground, stabilizing the panel. I don’t cut them super long, because I don’t want them to be weak. Just right in the middle is perfect. Set the panel up where you want it, right up tight against the T-post, then step on the bottom to press the prongs into the ground.

Step 5: Zip Tie Your Cattle Panel Trellis Together

I use three zip ties on my cattle panel trellises but you could probably get away with two.

Step 5: Plant!

I planted snake beans at the bottom of this trellis.

Also known as asparagus beans and yard-long beans, snake beans are a vigorous climbing bean that takes the heat of summer and produces abundant harvests.

I planted them about 8″ apart in a row along the base of my cattle panel trellis.

Step 6: Admire Your Work

That panel is going to look great covered in beans, isn’t it? I mean, I think it looks great right now. Like a work of ugly Brutalist fine architecture that would be at home in any urban hellscape modern city.

Trust me – it will look even better covered in beans.

Going vertical in your gardens allows you to produce much more in a smaller space. These simple, portable cattle panel trellises are just what the doctor ordered.

You can watch the video of me building one here:

Happy gardening!

Share this post!