Single Fisherman’s Bend Knot – Step by Step How to Tie It

[ad_1]

The Fisherman’s or Grapevine Bend is essentially just two hitches: one from the first line onto the second, and another from the second line onto the first. This makes it a strong, reliable knot, and fairly good for lines of different thicknesses. Especially in modern ropes it can have a tendency to jam shut and be very difficult to open.

The Fisherman’s Bend is very reliable even in slippery modern ropes, because each component is secure and closed independently of the other. This means they will probably stay closed even in the knot is agitated a lot.

animated single fisherman bend knot

The Fisherman’s Bend is favored by climbers for constructing loops (by tying two ends of one line together) for Prusiks.

The Fisherman’s Bend can slide open and closed, especially if the knots are not made too tightly, and in a slippery line. This makes it a great knot for bracelets and lanyards: bend the two ends of the bracelet or lanyard together with a Fisherman’s Bend, and it can be adjusted to slip on and off one’s wrist or neck.

Step1. Lay the ends of your two lines parallel:

single fisherman bend step 1 laying the ends
step 1

Step 2. Cross one working end over the other:

single fisherman bend step 2 crossing the two lines
step 2

Step3. Bring the working end down under everything, forming a loop around the other line:

single fisherman bend step 3 bringing working end down
step 3

Step 4. Cross the working end back up over itself, and then down through the loop. This makes an overhand knot:

single fisherman bend step 4 crossing working ends
step 4

Step 5. Begin the same process with the other end, though going always in the opposite direction. Where the first end went up over the other line, this end goes down:

single fisherman bend step 5
step 5

Step 6. Lay the new working end up and under everything. Again, this form a loop.

single fisherman bend step 6
step 6

Step 7. Thread the new working end through the loop, and make a second overhand knot.

single fisherman bend step 7

Final Step. By pulling the two standing end, tighten the two overhand knots back to back:

single fisherman bend knot
final step

Related Knots

  • The Overhand and Double, Triple, etc. Overhand Knots are the basic components of this knot, and are also stopper knots in their own right if tied in the end of a single line.
  • The Albright Knot, Nail Knot and Becket Hitch are all also bends which are essentially just a hitch of one line to another (though the fisherman’s Bend Hitches both lines to each other).

In Conclusion

A very strong hitch, though sometimes difficult to untie (especially if welded shut) this is a good knot for permanently attaching almost any two lines together.

single fisherman bend Pinterest image

[ad_2]

Source link

Get more stuff like this
in your inbox

Don't Be Left Unprepared

Thank you for subscribing.

Something went wrong.